Cable Fault Pre-Locator TDR Tester 10.1-Inch Touch Screen 400MHz Sampling 120km Range Multi-Pulse Coupler | XHGG502A

The XHGG502A cable fault tester adopts an industrial-grade 10.1-inch touch-integrated computer with a simple operating software interface, enabling human-machine interactive testing. It uses industrial-grade integrated circuit design and an embedded operating system to achieve signal filtering, acquisition, data processing, graphic display and graphic analysis, completing cable speed measurement, cable length test, cable fault distance test and resistance test.

This cable fault tester is a special instrument for measuring and analyzing the condition and fault distance of power cables. It is suitable for low-resistance, short-circuit, open-circuit and disconnection faults of power cables, high-frequency coaxial cables, street light cables and buried wires of various materials, cross-sections and media, as well as high-resistance leakage and flashover high-resistance faults.

Work mode: TDR (low voltage pulse), ICE (Impulse current), ARM (Arc reflection method) with coupler configured.

• Industrial-grade 10.1-inch full-color TFT touch screen with a simple and stable embedded system;
• Functions of cable wave speed test, cable length test and fault distance test;
• Fully automatic continuous sampling, real-time waveform capture, timely and accurate;
• Automatic test range setting and automatic waveform analysis to display the test distance;
• Two operation modes of touch and coded buttons, simple, fast and reliable;
• Equipped with low-voltage pulse method, high-voltage flashover method and multiple pulse method (8 times) testing technologies, smooth waveform display and easy interpretation;
• When using the multiple pulse method, it is used with the pulse coupler to display 8 groups of high and low voltage waveforms for easy comparison;
• Massive test waveform storage: waveforms tested on site can be stored and retrieved for analysis;
• Ultra-high brightness LED backlight of 280 nits with 1024*600 resolution, suitable for direct sunlight environments;
• Built-in high-capacity lithium battery pack with fast charging, enabling testing in environments without power;
• Adopts a protective chassis not lower than IP54.

Based on the traveling wave principle, the XHGG502A applies pulse signals to the cable under test and captures the echoes reflected at the fault point where the characteristic impedance changes, converting the reflection time into a precise fault distance. Four testing methods are integrated to cover faults from low resistance to high-resistance flashover:

This instrument provides power engineers with a reliable, comprehensive solution for power cable condition assessment and fault pre-location, helping minimize outage time through rapid and accurate fault distance measurement.