The XHHV535-4TSB is an integrated cable fault location system for power cables rated 35 kV and below. It combines a cable fault tester and a high-voltage pulse generator on one trolley, and is used to locate main insulation faults and to calibrate cable length.
The tester uses a 10.1-inch colour TFT touch display, a microcontroller-controlled embedded system and a built-in lithium battery. The high-voltage generator is supplied from AC 220 V and provides DC withstand, single-pulse and periodic-pulse outputs, with a signal feedback path for the tester, zero-position protection and automatic discharge after shutdown.
This page is written for cable fault location service teams and 35 kV cable maintenance groups that need pre-location and fault distance measurement on site.
| Parameter | Specification |
|---|---|
| Sampling frequency | 1 MHz – 400 MHz |
| Low-voltage pulse amplitude | 300 V ± 15 % |
| Distance range | ≥ 120 km |
| Test ranges | 100 m / 300 m / 500 m / 1 km / 3 km / 5 km / 10 km / 25 km / 50 km / 100 km |
| Pulse widths | 0.1 / 0.3 / 0.6 / 1.2 / 2.4 / 5.0 / 7.5 / 10 µs |
| Minimum resolution | 0.07 m |
| Test blind zone | ≤ 10 m |
| Measurement error | ≤ ± (0.5 % × L + 1 m), L = cable length |
| Power supply | Built-in 10.4 Ah lithium battery; charge about 2 h; operation more than 5 h |
| Working conditions | -20 °C to +65 °C; RH 90 %; 750 ± 30 mmHg |
| Parameter | Specification |
|---|---|
| Impulse voltage | 0 – 32 kV / 0 – 16 kV / 0 – 8 kV, three ranges |
| HV side current | 0 – 60 mA |
| HV accuracy | Class 2.5 |
| Built-in capacitor | 4 µF / 32 kV; 16 µF / 16 kV; 64 µF / 8 kV, three ranges |
| Discharge energy | 2048 J for each range |
| Output polarity | Negative |
| Impulse timing | Automatic about 7 s; manual arbitrary |
| Overcurrent protection | 9 A (> 5 s) on the low-voltage side |
| Over-temperature protection | 105 °C |
| Maximum power | 2000 W |
| Working supply | AC 220 V ± 10 %, 50 Hz |
Overall Rating
Rating Snapshot
The following is the distribution of all ratingsAll Reviews